How to use a bench vise

When the table vise is installed on the clamping table, the working surface of the fixed clamp body must be outside the edge of the clamping table to ensure that the lower end of the workpiece is not impeded by the edge of the clamping table when clamping a long workpiece. The center hole of the rotary base should face inward so that the clamp table is more stressed and does not crush the clamp table. In the clamp table mounted on the bench vise after the operator to work at a more appropriate height, generally more than the height of the jaws just flush with the elbow is appropriate, that is, the elbow is placed on the highest point of the bench vise half a fist, fist just against the jaw, the length and width of the clamp table with the work depends on.